INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 493)

15 - 19
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
6 When the Detach procedure is complete, a message will appear confirming a
successful detachment. See
Figure 15-27 .
Figure 15-27 Detach Successful
NOTE: To place the Service Module in storage see section 15.10, Storing the
Service Module, on page 15-20 .
15.8.2 Using the Front Panel Display to Detach
1 Touch Menu or push MENU.
2 Touch the PROBES & SM icon. Alternately, push the STAT button until the
PROBES & SM page is displayed.
3 Touch the DETACH SM button. Alternately, using the arrow keys, highlight the
DETACH SM button. Push OK SEL
4 A bar graph displaying the progress of the Detach procedure will appear on the
front panel of the HAPSITE.
5 The message Service Module Found, Not Attached will be displayed on the
screen.
CAUTION
Wait until the Turbo Speed reads zero before physically
removing the HAPSITE from the Service Module.
6 To place the Service Module in storage, see section 15.10, Storing the Service
Module, on page 15-20 .
15.9 Physically Removing the HAPSITE from the Service Module
The HAPSITE cannot be physically removed from the SM until a "Detach SM" has
been performed. Refer to
section 15.8, Detaching the HAPSITE, on page 15-17
before physically removing the HAPSITE from the Service Module.
After the HAPSITE has been detached from the Service Module, release the
latches on each side of the Service Module.
HINT: To continue using the HAPSITE, place a charged battery in the HAPSITE
or connect exterior power before removing the HAPSITE from the docked
position on the Service Module.