INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 181)

4 - 9
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
4.1.7.2 Setting Up Plus IQ for Communication with the HAPSITE
The first step to communication between the HAPSITE and Laptop is to set up a
Sensor Icon in Plus IQ. This is the HAPSITE Icon seen on the bottom of the System
Setup window of Plus IQ. See
section 8.6.1, Setting Up Communications, on page
8-13 for instructions.
The second step to setting up communications is to set the IP address of the
Laptop computer for direct communication with the HAPSITE. Instructions for this
are found in
section 8.6.2, Configuring the HAPSITE for Communications, on page
8-15 .
In order for wireless communication between the Laptop and HAPSITE Plus to be
successful, the radio on the Laptop computer must be turned on. The basic steps
for configuring the Laptop for wireless communication are:
1 Enable the radio on the Laptop computer.
2 Scan for available Wireless Networks.
3 Choose HAPSITE Plus.
4 Create a profile for the Wireless Connection.
5 Connect to the HAPSITE Smart Plus wireless network.
6 Verify the connection protocol is 802.11b.
7 If the connection protocol is not 802.11b, modify the profile.
Due to differences in computer models and brands, refer to the User’s Guide of the
Laptop for specific instructions on setting up the wireless radio. The Dell™ website
has a section on wireless communications called the Wireless Center. This section
can be accessed at
http://support.dell.com by clicking the Technical Support tab,
then selecting Wireless Center. The content applies to many manufacturer’s laptop
computers, in addition to Dell Laptop computers.