beautypg.com

INFICON HAPSITE Smart Plus Chemical Identification System User Manual

Page 55

background image

2 - 17

IP

N 07

4-

47

2-

P1

C

HAPSITE Smart Plus Operating Manual

7

The white label THIS END TO ACCESSORY on the insulation should coincide
with the white label THIS END TO ACCESSORY on the Transfer Line. See

Figure 2-24

. When alignment is correct, slide the insulation into place.

Figure 2-24 Accessory End of the Transfer Line

8

Install the Transfer Line between the HAPSITE and Headspace Sampling
System. First, disconnect the Probe from the HAPSITE. Install the LEMO
connector, which is labeled, THIS END TO HAPSITE, in the HAPSITE
connector. The opposite end labeled, THIS END TO ACCESSORY, will
connect to the rear of the Headspace Sampling System. See

Figure 2-26

. Make

sure the red dots on the Transfer Line connectors align with the marks on the
HAPSITE and Headspace Sampling System connectors.

Figure 2-25 Attaching the Transfer Line to the HAPSITE