8 service module, 1 setting up the service module – INFICON HAPSITE Smart Plus Chemical Identification System User Manual
Page 57
2 - 19
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
10
If using the HSS in portable mode, a battery will need to be installed. Open the
front door of the HSS and insert a charged battery into the rectangular slot
below the round carrier gas slot. Make sure when inserting the battery that the
lettering is right-side up to insure proper orientation. When inserted correctly, it
will click into place and remain snug. After battery has been properly installed,
disconnect the AC/DC power supply. See
Figure 2-28
. (For further instructions
on battery installation see
)
CAUTION
Do not open in a contaminated area. The HSS is not
sealed against moisture, debris or contamination with
the front door open.
Figure 2-28 Inserting the Battery into the HSS
2.8 Service Module
The Service Module is used to create a vacuum in the HAPSITE. It cannot be used
in a portable application.
For additional information on the Service Module, refer to
2.8.1 Setting Up the Service Module
Required Components
RS-232 communication cable.
Power cord for Service Module.
Laptop with Plus IQ software installed.
When stored, the Service Module should have an aluminum plug placed on the top
opening. This plug is used to keep the Service Module free of moisture and debris.