INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 326)

9 - 18
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
9.6.1 Using the Zoom Function in the TIC/RIC Window
There are two ways to Zoom into a TIC/RIC:
1 Move the mouse cursor to the Magnifying glass with the "+" inside. When the
Left Mouse Button (LMB) is clicked, there will appear two vertical lines on the
TIC/RIC graph window. Place the cursor on one of the vertical lines. Click and
hold the LMB. Drag the vertical line to where zooming may begin. Repeat the
actions of the previous sentence for the second vertical line. See
Figure 9-16 .
Once the Zoom range has been set, move the mouse cursor within the range.
The cursor will turn into a magnifying glass. Click the LMB, and the display will
Zoom in on the area selected.
Figure 9-16 Selecting Area to Zoom
2 Press and hold the LMB at the point in the TIC where Zoom should begin. A
vertical line will appear. Drag the cursor to the position that Zoom should end,
and release LMB. Place the mouse cursor within the two vertical lines. The
cursor will turn into a magnifying glass. Click the LMB, and the display will zoom
in on the area selected. Refer to
Figure 9-17 .