INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 154)

3 - 60
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
3.7.2 Accessories
The Accessories icon will display information regarding the current configuration
of the HAPSITE. If the Air Probe is installed, an icon of the probe will be displayed.
Touching the PROBE icon will display the installed version of the probe’s firmware.
The SKIP HEATER option allows for the HAPSITE to run when the probe is not at
temperature. This is useful in cold climates, when it may be difficult for the probe
to heat to the set point temperature. See
Figure 3-100 .
Figure 3-100 Probe Icon
If the Service Module is attached, the Service Module icon will be shown. Touching
the Service Module icon will display the installed version of the service module’s
firmware and the turbo speed of the service module’s pump. Options for attaching
and detaching the service module can be found through this screen. For more
information on the service module, see the Service Module Operating Manual.
The Headspace Sampling System (HSS) icon will appear when it is attached to the
HAPSITE. Touching the HSS or SituProbe icon will display the information
regarding the firmware version and accessory’s heaters. See the Headspace
Sampling System and SituProbe Purge and Trap Sampling Systems’ manuals for
further information.