INFICON HAPSITE Smart Plus Chemical Identification System - Manual (Page 290)

8 - 14
IP
N 07
4-
47
2-
P1
C
HAPSITE Smart Plus Operating Manual
3 Enter the letter "H", followed by the last 3 or 4 significant digits of the Serial
Number of the HAPSITE that requires communication setup. (The Serial
Number can be found on the inside front cover of the HAPSITE or by touching
the HAPSITE icon, then the HAPSITE System icon and then the NET button.)
For example: "H1086". Select Add. See
Figure 8-20 .
Figure 8-20 Add HAPSITE
4 The newly added HAPSITE will appear in the HAPSITE List. Press OK.
5 Press OK on the System Properties Window.
6 The newly added HAPSITE icon will now appear at the bottom of the System
Setup Window. If the HAPSITE appears as in
Figure 8-21 , then
communications have been established.
Figure 8-21 Newly Added HAPSITE
6a If the HAPSITE icon appears with a Blue "X" through the icon, then
communication has not been fully established. See
Figure 8-22 .
Figure 8-22 Communication Has Not Been Established
6b Continue with Configuring the HAPSITE for Communications, see section
8.6.2 .
NOTE: If the HAPSITE is shown with an a Blue "X", setting up the HAPSITE
for communication using the IP address can also be tried.