MagTek EC2000 99875607 - Manual (Page 88)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 88
4.9 How to Remove / Re-install the XY Transport Module
Approximate time to remove: 15 minutes plus any sub-procedures
Approximate time to re-install: 15 minutes plus any sub-procedures
The XY transport receives cards from the image printer module and moves them to the embosser module,
then to the exit transport module. It is located along the left side of the device.
Figure 4-65 - Removing and Re-Installing the XY Transport Module (FRONT RIGHT VIEW)
Follow these steps to remove the XY transport module from the device:
1) Prepare the device for replacing parts by following the steps in section 4.1 How to Prepare the
Device for Removing / Re-installing Modules. At the end, the device should be powered down with
all external cables safely disconnected.
2) Disengage and lean back the top access door by following the steps in section 4.2 How to Remove /
Re-install the Top Access Door up to the point where the top access door is leaning up and back
behind the device.
3) Move the XY transport toward the front of the device (see section 2.8 How to Safely Move
Transports By Hand).
4) Locate the XY transport’s ground cable, which is connected to the deck plate behind the image printer
as shown in Figure 4-66.