MagTek EC2000 99875607 - Manual (Page 64)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 64
4) Remove all the card stock hoppers and set them aside in a secure location, or give them to the
customer for secure temporary storage.
Figure 4-31 - Save Removal Location for Hopper Transport (TOP VIEW FROM FRONT)
5) Disconnect the two sensor cables from the rear right of the hopper deck (see Figure 4-32). Look at
the labels or colors of each cable, noting which cable is plugged in to the connector closer to the front,
and which is plugged in to the connector closer to the rear.
Figure 4-32 - Two Hopper Module Sensor Cables (FRONT RIGHT VIEW)
6) Locate the HOPPER SHUTTLE breakout circuit board mounted to the top deck plate below the
center of the hopper module (see Figure 4-33).
7) Unplug the HOME SENS and EXC HOME SENS cables from the breakout board.
8) If EXC HOME SENS is routed underneath the breakout board, carefully thread it out and free it.
9) Trace the cables back to the hopper module and cut any cable ties holding them to the top deck plate.
Leave the cut cable ties in place to mark the mount points, and to loosely hold any other cables you
are not removing.