MagTek EC2000 99875607 - Manual (Page 80)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 80
To re-install the image printer module, follow these steps:
1) Clear all cables out of the way to make room on the top deck plate for the replacement image printer.
2) Carefully lower the replacement image printer, tilted slightly downward toward the hoppers, and line
up the screw holes in its base with the screw holes in the top deck plate.
3) Make sure the downward-facing sheet metal tabs in the base of the image printer insert into the
corresponding slots on the top deck plate (see Figure 4-55). You may have to push a bit on the sheet
metal of the image printer’s base to line up the tabs.
Figure 4-55 - Seat Image Printer Tabs In Slots (TOP RIGHT VIEW)
4) Use the 5/32” Allen wrench to re-fasten the screws and washers that secure the image printer to the
top deck plate (see Figure 4-51).
5) Re-connect the power cable, reconnect the card exit sensor, and reconnect the USB cable to J31.