MagTek EC2000 99875607 - Manual (Page 115)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 115
Figure 4-95 - Connectors Near Right Edge of Embedded PC (TOP VIEW FROM RIGHT)
7) Slowly and carefully continue to pull the embedded PC out further until you can see the remaining
cables connected to its left half, as shown in Figure 4-96. While pulling, use a flashlight and other
tools as appropriate to make sure its cables do not snag inside the device.
8) Support the embedded PC with your hand or on the tabletop while completing the final steps.
Figure 4-96 - Embedded PC Left Edge Visible (TOP VIEW FROM RIGHT)
9) Disconnect the remaining cables (see Figure 4-97), including at least two ribbon cables connected to
COM1 and COM2, and one ribbon cable connected to the multi-colored front panel connector. If
there is silicone adhesive holding any of the connectors, remove it completely.