MagTek EC2000 99875607 - Manual (Page 46)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 46
Figure 4-3 - Top Access Door Leaning Up and Back (FRONT VIEW)
6) Move the hopper transport toward the front of the device, around hopper 6 (see section 2.8 How to
Safely Move Transports By Hand).
7) Remove card stock hoppers 1 and 2.
8) Locate the screw and washer that fasten the cover to the metal plate on the rear of the base. The
fastener can be found in the rear upper right of the device behind hopper 1, as shown in Figure 4-4.
Figure 4-4 - Removing the Right Side Cover Screw Near Top Access Door Hinge (FRONT LEFT VIEW)
9) During the next step, hold the top access door with one hand or it may fall or break.
10) Use the No. 2 Philips screwdriver to loosen the fastener.
11) Remove the top access door and set it aside with the two screws and washers (if necessary, move the
XY transport out of the way per section 2.8 How to Safely Move Transports By Hand).