MagTek EC2000 99875607 - Manual (Page 50)

4 - Removal and Re-installation
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 50
4.4 How to Remove / Re-install the Cover
Approximate time to remove: 30 minutes plus any sub-procedures
Approximate time to re-install: 45 minutes plus any sub-procedures
The EC2000 has a cover which secures the device’s contents and provides mount points for the top access
door and touchscreen, and incorporates the card output hopper and manual feed slot. Some service
procedures require removing the device’s cover to give unobstructed access to certain components.
Figure 4-9 – Cover (REAR LEFT VIEW, REAR RIGHT VIEW)
Follow these steps to remove the cover:
1) Prepare the device for replacing parts by following the steps in section 4.1 How to Prepare the
Device for Removing / Re-installing Modules. At the end, the device should be powered down with
all external cables safely disconnected.
2) Remove the top access door by following the steps in section 4.2 How to Remove / Re-install the
Top Access Door, including safely powering down and disconnecting external cables.
3) Remove the magnetic stripe reader by following the steps in section 4.20 How to Remove / Re-
install the Magnetic Stripe Reader (MSR) Module.
4) Remove all the card stock hoppers from the device and set them aside. Remember to move the
hopper transport out of the way as you remove them (see section 2.8 How to Safely Move
Transports By Hand for more information).