MagTek EC2000 99875607 - Manual (Page 10)

2 - Introduction
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 10

Do not place an ESD-sensitive part on the device or on a metal table; put it in an ESD bag or on an
ESD mat.

Use extra caution when working under climate conditions that increase the potential for ESD, such as
cold weather or low humidity.
2.4 Introduction to EC2000 Components
For an introduction to identifying the components of the EC2000, see 99875600 EC2000 User
Installation and Operation Manual.
This manual uses the words “Front,” “Rear,” “Left,” and “Right” to describe where to find various parts
of the device. These terms assume the reader is standing in front of the device facing the touchscreen,
and are shown in Figure 2-1. During service, it is normal to move around the device to get easier access
to parts. In the same way, many of the photos and drawings in this manual show the device from different
angles that make key “landmarks” visible. In these cases, the caption will generally state the direction the
figure can be seen from (for example, “FRONT RIGHT VIEW”).
Figure 2-1 – Front/Rear/Left/Right Definition (TOP VIEW)
2.5 Device Specifications
For Electrical, Acoustical, Environmental, Communication, Physical, Encoding, and other detailed
specifications of the EC2000, see 99875600 EC2000 User Installation and Operation Manual.