6 how to calibrate card flatness, 5 - adjustments – MagTek EC2000 99875607 User Manual
Page 154
5 - Adjustments
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 154
2) If the embossed character thickness is between 0.017 in. and 0.019 in. and the card is flat, skip to
section 5.4.7 How to Fine-Tune Embossed Character Height Using Software.
3) If the lowest FontID1 thickness you measured is less than 0.0120 in.:
a) In the ExpressCard 2000 Utility, navigate to
Menu
>
Settings
>
Edit Config
to open the
Configuration Editing
password page.
b) Use the onscreen keypad to enter password
1234567
and press the
E
key.
c) Use the onscreen keypad to enter password
7654321
and press the
E
key.
d) Scroll through the settings list to find FontID1 CamAngleTop and FontID1 CamAngleBottom.
e) Select FontID1 > CamAngleTop, add 10 to the current setting, enter the new value in the text
entry box at the top right of the screen, and press the
E
key.
f) Select FontID1 > CamAngleBottom, add 10 to the current setting, enter the new value in the
text entry box at the top right of the screen, and press the
E
key.
g) Press the
Save
button to save the new settings.
h) Repeat all steps in section 5.4.5.
4) If the highest FontID1 thickness you measured is less than 0.0170 in.:
a) If the card is bent concave down (“frowning”), increase the pressure of the top knuckle by
adding 1 to the current setting (see Figure 5-3).
b) If the card is bent concave up (“smiling”), increase the pressure of the bottom knuckle by adding
1 to the current setting (see Figure 5-3).
c) Repeat all steps in section 5.4.5.
5) If the highest FontID1 thickness you measured is higher than 0.0190 in.:
a) If the card is bent concave up (“smiling”) decrease the pressure of the top knuckle by
subtracting 1 from the current setting (see Figure 5-3).
b) If the card is bent concave down (“frowning”), decrease the pressure of the bottom knuckle by
subtracting 1 from the current setting (see Figure 5-3).
c) Repeat all steps in section 5.4.5.
6) Repeat section 5.4.5 for FontID2.
5.4.6 How to Calibrate Card Flatness