MagTek EC2000 99875607 - Manual (Page 22)

2 - Introduction
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 22
1) Verify the EC2000 software supports the character(s) you are going to install.
2) Look at the numbers stamped on each daisy wheel tine to find the number of the tine where you will
install the new character.
3) Install the character on the tine. Every character has a piece on the top daisy wheel and a second
piece on the bottom daisy wheel, so make sure to install both, and to put each piece on the correct
half: For embossing fonts and rear indent fonts (FontID1, FontID2, and FontID4), the “punch”
(positive) side goes on the bottom; for front indent fonts (FontID3), the “punch” side goes on the top.
Indent fonts have a “blank” flat side that goes opposite the punch side.
4) Install both halves of the character on the new tine.
5) From the touchscreen, navigate to Menu > Settings > Service > Char Map to open the first
Character Mapping password page.
6) Enter password 4567890 , then press the E key to open the second Character Mapping password
page.
7) Enter password 0987654 , then press the E key to open the Character Mapping page.
8) Use the Add Char. dropdown list to select what character you are installing (for example, if you are
installing a capital ‘A,’ select 65). Verify you have selected the character you expected to select by
looking at the
ASCII Char box next to the dropdown list.
9) Use the Font dropdown list to indicate the type of font you have installed (FontID1-4).
10) Use the To dropdown list to select which tine you have installed the characters on.
11) Press the Add button.
12) Repeat the above steps for any additional characters you need to add.
13) Test your changes by creating a sample card or an embosser tuning card.