MagTek EC2000 99875607 - Manual (Page 42)

3 - Preventive Maintenance
ExpressCard 2000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 42
3.13 Service the Electronics
Visually inspect all wires and cables, checking for insulation breakage or wear on moving cables.
3.14 Service the Cover
After completing all other service, service the cover as follows:
1) Inspect the cover for damage.
2) Clean the black and gray portions of the outside of the cover with alcohol wipes.
3) Clean fingerprints off the touchscreen with a soft, clean, dry cloth.
3.15 Perform Final Tests
After completing preventive maintenance, follow these steps to test the device and restore it to its original
state:
1) Re-connect the power and network cables.
2) Re-attach any security hardware.
3) Re-install consumables.
4) Close all open doors.
5) Power up the device.
6) Re-synchronize the image printer ribbon.
7) Create a sample card using customer card stock.
8) Check image print quality and embosser alignment, and adjust components as necessary using the
information in section 5 Adjustments.
9) Fill out the checklist included with the preventive maintenance kit, and return it to MagTek.