Brocade Network OS Message Reference v4.1.1 - Manual (Page 476)

460 Network OS Message Reference
53-1003227-01
ZONE-1040
8
ZONE-1040
Message
Merged zone database exceeds limit.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the Network OS cannot read the merged zone configuration file. Typically, the zone
configuration is too large for the memory available on the switch.
Recommended
Action
Reduce the size of the zone database by deleting some zones and retry the operation. Refer to the
Network OS Administrator's Guide for instructions to delete a zone.
ZONE-1041
Message
Unstable link detected during merge at port ().
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates a possible unstable link or a faulty cable.
Recommended
Action
Verify that the small form-factor pluggable (SFP) transceiver and cable at the specified port are not faulty.
Replace the SFP transceiver and cable if necessary.
ZONE-1042
Message
The effective configuration has been disabled.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the effective zone configuration has been disabled.
Recommended
Action
Verify that the event was planned. If the event was planned, no action is required. If the event was not
planned, take appropriate action as defined by your enterprise security policy.
ZONE-1043
Message
The Default Zone access mode is set to No Access.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the default zone access mode is set to No Access.