Brocade Network OS Message Reference v4.1.1 - Manual (Page 130)

114 Network OS Message Reference
53-1003227-01
BL-1046
8
BL-1046
Message
error on SFP in Slot
number into which the SFP is inserted>/Port
access' for general problems accessing the i2c accessible data> (
code>). Reseat or replace the SFP.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that checksum in an area on the small form-factor pluggable (SFP) transceiver does not match
with the computed value or there is problem accessing the data.
Recommended
Action
Reseat the SFP transceiver. If the problem persists, replace the SFP transceiver.
BL-1047
Message
Buffer optimized mode is turned for slot .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the buffer optimized mode is changed for the specified slot.
Recommended
Action
No action is required.
BL-1049
Message
Incompatibility with an active 12x40G LC detected, faulting the interface module
in .
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that this line card (LC) is incompatible with one or more existing 12x40G LCs.
Recommended
Action
Power cycle all active 12X40G LCs and then power cycle the interface module using the power-off and
power-on commands. Then power on all 12X40G LCs. After completing these steps, all LCs can
interoperate with one another.