Brocade Network OS Message Reference v4.1.1 - Manual (Page 238)

222 Network OS Message Reference
53-1003227-01
FW-1433
8
FW-1433
Message
Switch status changed to faulty due to non-redundant MM: (M).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the switch is not in a healthy state. This occurred because the number of faulty
management modules is greater than or equal to the policy set by the system-monitor command. The
management modules are non-redundant.
Recommended
Action
Execute the show firmware command to verify if both the management modules have compatible
firmware levels. Execute the firmware download command to install the same level of firmware to both
management modules. Replace any faulty management modules.
If you reset the micro-switch (the latch on the management module) on the active management module
before the heartbeat was up on a power cycle, and the management modules came up non-redundant,
reload the management modules again to clear the problem.
FW-1434
Message
Switch status change contributing factor LC: LC failures (
Numbers>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the switch is not in a healthy state. This occurred because the number of line card (LC)
failures is greater than or equal to the policy set by the system-monitor command.
Recommended
Action
Replace the faulty LC.
FW-1435
Message
Switch status change contributing factor Flash: usage out of range.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the switch is not in a healthy state. This occurred because the flash usage is out of range.
The policy was set using the system-monitor command.
Recommended
Action
Execute the clear support command to clear the kernel flash.