Brocade Network OS Message Reference v4.1.1 - Manual (Page 28)

12 Network OS Message Reference
53-1003227-01
Configuring system messages
1
MESSAGE TYPE
LOG
SEVERITY
ERROR
PROBABLE CAUSE
Indicates that a a blade inserted in the specified slot or
the switch (for non-bladed switches) is incompatible with
the switch configuration software. The blade will not be
completely usable.
The blade may only be supported by a later (or earlier) ver-
sion of the firmware.
RECOMMENDED ACTION
Change the control processor (CP) firmware or replace the
blade. Make sure the replacement is compatible with your
switch type and firmware.
Configuring system messages
This section provides information on configuring the system message logs.
Disabling a RASLog message or module
To disable a single RASLog message or all messages in a module, perform the following steps.
1. Log in to the switch as admin.
2. Use the following commands to disable a single RASLog message or all messages that belong
to a module:
• Execute the logging raslog message message_ID suppress command to disable a RASLog
message. For example, execute the following command to disable the NS-1001 message:
switch:admin> logging raslog message NS-1001 suppress
2012/07/20-13:28:37, [LOG-1007], 375, M1, INFO, switch, Log message
NS-1001 RASLOG message has been disabled.
Use the show running-config logging raslog message message_ID command to verify the
status of the message.
• Execute the logging raslog module module_ID command to disable all messages in a
module. For example, execute the following command to disable all messages that belong
to the NSM module:
switch:admin> logging raslog module NSM
2012/07/20-13:28:37, [LOG-1007], 375, CHASSIS, INFO, switch, Log Module
NSM module RASLOG message has been suppress.
Use the show running-config logging raslog module module_ID command to verify the
status of the messages that belong to a module.