Brocade Network OS Message Reference v4.1.1 - Manual (Page 111)

Network OS Message Reference 95
53-1003227-01
AUTH-1042
8
AUTH-1042
Message
Port has been disabled, because authentication failed with code
'' and explanation ''.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified port has been disabled because the connecting switch or device failed to
authenticate. The error may indicate that an invalid entity attempted to connect to the switch.
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the show fcsp auth-secret dh-chap command and reinitialize
authentication using the shutdown and no shutdown commands or the chassis disable and chassis
disable commands.
If the message persists, execute the copy support command and contact your switch service provider.
AUTH-1044
Message
Authentication . Disabling the port .
Message Type
LOG | FFDC
Severity
ERROR
Probable Cause
Indicates that the authentication has timed out after multiple retries and as a result, the specified port has
been disabled. This problem may be transient due to the system CPU load. In addition, a defective small
form-factor pluggable (SFP) or faulty cable may have caused the failure.
Recommended
Action
Check the SFP and the cable. Then try to enable the port using the no shutdown command.
AUTH-3001
Message
Event: , Status: success, Info: type has been changed from
[] to [].
Message Type
AUDIT
Class
SECURITY
Severity
INFO
Probable Cause
Indicates that a authentication configuration parameter was set to a specified value. The data type can
be either authentication type, DH group type, hash type, or policy type.
Recommended
Action
No action is required.