Brocade Network OS Message Reference v4.1.1 - Manual (Page 358)

342 Network OS Message Reference
53-1003227-01
PORT-1003
8
PORT Messages
PORT-1003
Message
Port Faulted because of many Link Failures.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the specified port is disabled because of multiple link failures on the port that have
exceeded the threshold internally set on the port. This problem is related to the hardware.
Recommended
Action
Check and replace (if necessary) the hardware attached to both the ends of the specified port, including:
• The small form-factor pluggable (SFP)
• The cable (fiber-optic or copper inter-switch link (ISL))
• The attached devices
After checking the hardware, execute the no shutdown command to re-enable the port.
PORT-1004
Message
Port (0x) could not be enabled because it is
disabled due to long distance.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the specified port cannot be enabled because other ports in the same group have used the
buffers of this port group. This happens when other ports are configured to be long distance.
Recommended
Action
To enable the specified port, perform one of the following actions:
• Reconfigure the other E_Ports so that they are not long distance.
• Change the other E_Ports so that they are not E_Ports.
This will free some buffers and allow the port to be enabled.
PORT-1011
Message
An SFP transceiver for interface Fibre Channel /
number>/ is removed.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that a small form-factor pluggable (SFP) transceiver has been removed from the specified port.