Brocade Network OS Message Reference v4.1.1 - Manual (Page 27)

Network OS Message Reference 11
53-1003227-01
Displaying message content on the switch
1
Displaying message content on the switch
You can view the message documentation, such as the message text, message type, class (for
Audit messages), message severity, cause, and action, on the switch console by using the rasman
message id message_ID command.
To display the message documentation on the switch, perform the following steps.
1. Log in to the switch as admin.
2. Use the rasman message id message_ID command to display the documentation of a
message. The message_ID values are case-sensitive.
For example, execute the following command to display the documentation for EM-1059.
switch# rasman message id EM-1059
Miscellaneous EM-1059(7m)
MESSAGE
EM-1059 - with ID may not
be supported on this platform, check FOS firmware version as
a possible cause.
logging auditlog class This command sets the event classes for Audit log messages.
logging raslog console This command sets a filter based on the severity level for the messages to be
displayed on the system console.
logging syslog-facility local This command sets the syslog facility.
logging syslog-server This command configures a syslog server to which the switch can forward the
messages.
show logging auditlog This command displays the Audit log messages on the local switch or the specified
switches.
NOTE: This command can be disruptive because it displays all the logs in the buffer
continuously. Use | more to see output page by page.
show logging raslog This command displays the error log message on the local switch, the specified
switch, or interface module. The command includes options to filter the messages
based on the message attribute and the severity level, and also to set the count of
messages to display, and to display messages in reverse order.
NOTE: This command can be disruptive because it displays all the logs in the buffer
continuously. Use | more to see output page by page.
show running-config
logging This command is used to display the logging settings on the local switch.
show running-config
logging auditlog class This command displays the event class configured for the Audit log.
show running-config
logging raslog This command displays the RASLog console severity level on the local switch or the
specified switch.
show running-config
logging syslog-facility This command displays the syslog facility level.
TABLE 5 Commands for viewing or configuring the message logs (Continued)
Command Description