Brocade Network OS Message Reference v4.1.1 - Manual (Page 439)

Network OS Message Reference 423
53-1003227-01
SWCH-1001
8
SWCH Messages
SWCH-1001
Message
Switch is not in ready state - Switch enable failed switch status= 0x
status>, c_flags = 0x.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates failure to enable the switch because it is not in the ready state.
Recommended
Action
If the message persists, execute the copy support command and contact your switch service provider.
SWCH-1002
Message
Security violation: Unauthorized device tries to flogin to
port .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the specified device is not present in the authorized profile list.
Recommended
Action
Verify that the device is authorized to log in to the switch. If the device is authorized, execute the show
secpolicy command to verify whether the specified device World Wide Name (WWN) is listed. If it is not
listed, execute the secpolicy defined-policy command to add this device to an existing policy.
SWCH-1003
Message
Slot ENABLED but Not Ready during recovery, disabling slot = (
value>).
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the slot state has been detected as inconsistent during failover or recovery.
Recommended
Action
For a modular switch, execute the power-off and power-on commands to power cycle the interface
module.
For a compact switch, reload or power cycle the switch.