Brocade Network OS Message Reference v4.1.1 - Manual (Page 120)

104 Network OS Message Reference
53-1003227-01
BL-1010
8
Recommended
Action
Make sure that the interface module is seated correctly. If the interface module is seated correctly, reload
or power cycle the interface module using the power-off and power-on commands.
Execute the diag systemverification command to verify that the interface module does not have
hardware problems.
Execute the diag post command to make sure that Power-On Self-Test (POST) is enabled.
If the message persists, replace the interface module.
BL-1010
Message
Interface module in is inconsistent with the hardware settings.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a failover occurred while some hardware changes (such as changing the domain ID) were
being made on the previously active management module.
Recommended
Action
No action is required. This interface module has been re-initialized. Because re-initializing an interface
module is a disruptive operation and can stop I/O traffic, you must stop and restart the traffic during this
process.
BL-1011
Message
Busy with emb-port int for chip in minis on
interface module , chip int is disabled. Interrupt
status=0x.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that too many interrupts in the embedded port caused the specified chip to be disabled. The
probable cause is too many abnormal frames; the chip is disabled to prevent the management module
from becoming too busy.
Recommended
Action
Make sure to capture the console output during this process.
Check for a faulty cable, small form-factor pluggable (SFP) transceiver, or device attached to the
specified port.
Execute the diag systemverification command to verify that the interface module or switch does not
have hardware problems.
Execute the diag post command to make sure that Power-On Self-Test (POST) is enabled.
For a modular switch, execute the power-off and power-on commands to power cycle the interface
module.
For a compact switch, reload or power cycle the switch.
If the message persists, replace the interface module or the switch.