Brocade Network OS Message Reference v4.1.1 - Manual (Page 106)

90 Network OS Message Reference
53-1003227-01
AUTH-1026
8
AUTH-1026
Message
Failed to during negotiation phase: port .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the authentication failed to get device or host bus adapter (HBA) information due to an
internal failure. Usually this problem is transient. The authentication may fail.
Recommended
Action
Reinitialize authentication using the shutdown and no shutdown commands or the chassis disable
and chassis enable commands.
If the message persists, execute the copy support command and contact your switch service provider.
AUTH-1027
Message
Failed to select during : value
port .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the authentication process failed to select an authentication value (for example, DH group,
hash value, or protocol type) from a receiving payload during the specified authentication phase. This
error occurred because the local switch does not support the specified authentication value.
Recommended
Action
Check the authentication configuration and reset the supported value if needed using the fcsp auth
command.
Reinitialize authentication using the shutdown and no shutdown commands or the chassis disable
and chassis enable commands.
If the message persists, execute the copy support command and contact your switch service provider.
AUTH-1028
Message
Failed to allocate for : port .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the authentication process failed because the system is low on memory. Usually this
problem is transient. The authentication may fail.
The data type is a payload or structure that failed to get memory. The operation phase specifies which
operation of a particular authentication phase failed.