Brocade Network OS Message Reference v4.1.1 - Manual (Page 228)

212 Network OS Message Reference
53-1003227-01
FW-1043
8
FW-1043
Message
, is above high boundary(High=, Low=). Current value
is .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the transmit power value of the small form-factor pluggable (SFP) transceiver has risen
above the high boundary. The transmit performance area measures the amount of outgoing laser to help
you determine if the SFP transceiver is in good working condition or not. If the counter often exceeds the
threshold, the SFP transceiver is deteriorating.
Recommended
Action
Replace the SFP transceiver.
FW-1044
Message
, is between high and low boundaries(High=, Low=).
Current value is .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the transmit power value of the small form-factor pluggable (SFP) transceiver has changed
from a value outside of the acceptable range to a value within the acceptable range. The transmit
performance area measures the amount of outgoing laser to help you determine if the SFP transceiver is
in good working condition or not. If the counter often exceeds the threshold, the SFP transceiver is
deteriorating.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
FW-1046
Message
, is below low boundary(High=, Low=). Current value
is .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) transceiver voltage has fallen below the
low boundary.
Recommended
Action
Verify that your optical components are clean and functioning properly. Replace deteriorating cables or
SFP transceivers. Check for damage from heat or age.