Brocade Network OS Message Reference v4.1.1 - Manual (Page 310)

294 Network OS Message Reference
53-1003227-01
MSTP-3001
8
Recommended
Action
No action is required.
MSTP-3001
Message
Could not restore spanning tree protocol settings from startup-config. Spanning
tree is configured in shutdown state.
Message Type
DCE
Severity
ERROR
Probable Cause
Indicates that allocation of logical bridge ID has failed. The VCS cluster formation could be in progress.
Recommended
Action
Wait for cluster formation to complete and then enable the Spanning Tree Protocol using the no
spanning-tree shutdown command. You may have to execute the shutdown command followed by the
no shutdown command from protocol spanning-tree submode.
MSTP-3002
Message
Could not restore spanning tree state for interface .
Message Type
DCE
Severity
ERROR
Probable Cause
Indicates that allocation of logical port ID has failed. The VCS cluster formation could be in progress.
Recommended
Action
Wait for cluster formation to complete and then enable the spanning tree on the interface. You may have
to execute the spanning-tree shutdown command followed by the no spanning-tree shutdown
command from interface submode.
MSTP-3003
Message
Could not restore spanning tree state for interface . Maximum port count
reached.
Message Type
DCE
Severity
ERROR
Probable Cause
Indicates that the system ran out of port ID space, probably due to stale entries in the system. The
maximum port count for STP and PVST is 1 through 255, and for RSTP, MSTP, and RPVST the
maximum port count is 1 through 4095.
Recommended
Action
Shut down spanning tree on interfaces that are no longer required using the spanning-tree shutdown
command and try the operation again.