Fabs-1005, Fabs-1006 – Brocade Network OS Message Reference v4.1.1 User Manual
Page 193
Network OS Message Reference
177
53-1003227-01
FABS-1005
8
FABS-1005
Message
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that an unsupported operation has been requested. This is usually an internal Network OS
problem or file corruption. The following is the possible value for the function name and description of
problem variable:
fabsys_write: Unsupported write operation: process xxx
The xxx value is the process ID (PID), which could be any whole number.
Recommended
Action
Reload or power cycle the active management module (for modular systems) or the switch (for compact
systems).
If the message persists, execute the firmware download command to update the firmware.
FABS-1006
Message
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that there is no device in the slot with the specified object type ID in the system module record.
This could indicate a serious Network OS data problem on the switch. The following are the possible
values for the function name and description of problem variable:
•
setSoftState: bad object
•
setSoftState: invalid type or unit
•
media_sync: Media oid mapping failed
•
fabsys_media_i2c_op: Media oid mapping failed
•
fabsys_media_i2c_op: obj is not media type
•
media_class_hndlr: failed sending media state to blade driver
Recommended
Action
If the message is isolated, monitor the error messages on the switch. If the error is repetitive or if the
fabric failed, fail over or reload the switch.
If the message persists, execute the firmware download command to update the firmware.