Brocade Network OS Message Reference v4.1.1 - Manual (Page 195)

Network OS Message Reference 179
53-1003227-01
FABS-1010
8
FABS-1010
Message
: Wrong media_event .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the Network OS detected an unknown event type. This is usually an internal Network OS
problem or file corruption.
Recommended
Action
Reload or power cycle the switch.
If the message persists, execute the firmware download command to update the firmware.
FABS-1011
Message
[]:Invalid input state 0x.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that an unrecognized state code was used in an internal Network OS message for a
field-replaceable unit (FRU).
Recommended
Action
Reload or power cycle the management module or switch.
If the message persists, execute the firmware download command to update the firmware.
FABS-1013
Message
[]:Unknown interface module type 0x
module type>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that an unrecognized type of interface module has been discovered in the system.
This error can be caused by one of the following reasons: an incorrect field-replaceable unit (FRU)
header, inability to read the FRU header, or the interface module may not be supported by this platform
or Network OS version.
Recommended
Action
Verify that the interface module is valid for use in this system and this version of Network OS.
Reseat the interface module.
If this is a valid interface module and reseating does not solve the problem, replace the interface module.