Brocade Network OS Message Reference v4.1.1 - Manual (Page 175)

Network OS Message Reference 159
53-1003227-01
EM-1033
8
EM-1033
Message
MM in is reloading.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the standby management module has been detected to be in the reload process. The high
availability (HA) feature will not be available. This message occurs every time the other management
module reloads, even as part of a clean warm failover. In most situations, this message is followed by the
EM-1047 message, and no action is required for the management module; however, if the failover was
not intentional, it is recommended to find the reason for the failover.
Recommended
Action
If the standby management module was just reloaded, wait for the error to clear (execute the show slots
command to determine if the errors are cleared). Watch for the EM-1047 message to verify that this error
has cleared.
If the standby management module state changes to faulty or if it was not intentionally reloaded, check
the error logs on the other management module (using the show logging raslog command) to
determine the cause of the error state.
Reseat the field-replaceable unit (FRU). If the problem persists, replace the FRU.
EM-1034
Message
is set to faulty, rc=.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified
reason.
Recommended
Action
Reseat the FRU.
Execute the diag systemverification command to verify that the switch does not have hardware
problems.
If the problem persists, replace the FRU.
EM-1036
Message
is not accessible.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the specified field-replaceable unit (FRU) is not present on the switch.
If the FRU is a Chassis ID (CID) card, then the default WWN and IP addresses are used for the switch.