Brocade Network OS Message Reference v4.1.1 - Manual (Page 229)

Network OS Message Reference 213
53-1003227-01
FW-1047
8
FW-1047
Message
, is above high boundary(High=, Low=). Current value
is .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) transceiver voltage has risen above the
high boundary.
Recommended
Action
The supplied current of the SFP transceiver is outside of the normal range, indicating possible hardware
failure. If the current rises above the high boundary, replace the SFP transceiver.
FW-1048
Message
, is between high and low boundaries(High=, Low=).
Current value is .
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) transceiver voltage has changed from a
value outside of the acceptable range to a value within the acceptable range.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the end-user
installation.
FW-1050
Message
, is below low boundary(High=, Low=). Current value
is .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the value of the small form-factor pluggable (SFP) transceiver voltage has fallen below the
low boundary.
Recommended
Action
Configure the low threshold to 1 so that the threshold triggers an alarm when the value falls to 0
(Out_of_Range). If continuous or repeated alarms occur, replace the SFP transceiver before it
deteriorates.