Brocade Network OS Message Reference v4.1.1 - Manual (Page 103)

Network OS Message Reference 87
53-1003227-01
AUTH-1010
8
AUTH-1010
Message
Failed to initialize security policy: switch , error .
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates an internal problem with the security policy.
Recommended
Action
Reload or power cycle the switch.
If the message persists, execute the copy support command and contact your switch service provider.
AUTH-1012
Message
Authentication is rejected: port explain
reason .
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the specified authentication is rejected because the remote entity does not support
authentication.
Recommended
Action
Make sure the entity at the other end of the link supports authentication.
AUTH-1013
Message
Cannot perform authentication request message: port , message code
.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the system is running low on resources when receiving an authentication request. Usually
this problem is transient. The authentication may fail.
Recommended
Action
Reinitialize authentication using the shutdown and no shutdown commands or the chassis disable
and chassis enable commands.
If the message persists, execute the copy support command and contact your switch service provider.