Brocade Network OS Message Reference v4.1.1 - Manual (Page 255)

Network OS Message Reference 239
53-1003227-01
HASM-1101
8
HASM-1101
Message
HA State out of sync.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the high availability (HA) state for the active management module is out of synchronization
with the HA state of the standby management module. If the active management module failover occurs
when the HA state is out of sync, the failover is disruptive.
Recommended
Action
If this message was logged as a result of a user-initiated action, no action is required.
Execute the ha dump command to diagnose the problem.
If the problem persists, execute the copy support command and contact your switch service provider.
HASM-1102
Message
Heartbeat misses to reached threshold.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that either the active management module Ethernet Media Access Controller (EMAC) or the
indicated interface module is down. The active management module will run a diagnostic test on the
EMAC and will wait for the interface module to reset it if it is down.
Recommended
Action
No action is required.
HASM-1103
Message
Heartbeat to down.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the active management module has detected that the indicated interface module is down.
This event may happen as a result of one of the following conditions: an operator-initiated action such as
firmware download, if the interface module is reset or removed, or an error occurred in the interface
module.
Recommended
Action
Monitor the interface module for a few minutes. If this message is due to reloading of the interface
module, a message indicating heartbeat up will be displayed after the interface module has reloaded
successfully.
If the interface module does not successfully connect to the active management module after 10
minutes, reload the interface module by ejecting the interface module and reseating it.