Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 73)

Easy Mode Catalyst Enterprises, Inc.
59
Timing Analysis - Synchronous
Make sure that the TA700/800 is in the State & Timing Analyzer configuration and is
operating in the Easy Mode as shown on the Main Menu bar below.
This mode of operation is not supported by the TA700PDC, TA800 or PCI-X
In this mode you may immediately detect and capture timing violations on all bus
signals. Any bus “glitch” of 1.5 ns or greater is captured as a timing violation.
You may also perform a Setup/Hold Limits search on any or all PCI bus signals by
using a convenient signal mask.
Caution: When performing measurements at 66.6MHz, make sure extender switch
if OFF.
Figure 51 Timing Violation Analysis Dialog Box
To perform an immediate timing analysis, click the Timing Violation
Icon to open the Timing Violation Analysis dialog box.