Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 20)

Catalyst Enterprises, Inc. Installing Your Analyzer
6
Figure 4 Install Component Selection
4. Select the desired components for installation.
5. Click Next to complete the installation.
System Restart After installing the TA700/800 software you must restart your computer
before you can use your analyzer software.
USB Driver During installation of the TA700_TA800 software automatically installs
the USB driver, which will require the system to be rebooted. When the
TA700/TA800 is attached to the system using the USB port, the system
will search for the correct driver for the TA700/TA800. This step may
require some user interaction, the user should only need to press next, and
the system should find the correct driver. If this step does not work, please
refer to the next section for details on how to manually install the USB
Driver.
PCI Driver If at the end of installation the operating System requests a PCI driver,
then you must manually point to the PCI driver folder.
Manual USB Driver Installation
To control the TA700/800 via the USB bus perform the following:
1. Power Up the TA700/800
2. Connect the USB cable between the TA700/800 USB Port interface and the
Host Computer USB port.
3. After Windows detects the new device, select the “Search For Best Driver for
Your Device” option button.
4. Click Next.
5. Choose the “Specific location” option button and deselect all other option
buttons.
• Click Next