Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 119)

Performance Analysis Catalyst Enterprises, Inc.
105
Creating a New Analysis Project
To create a new analysis program you must define/program:
• Performance Analysis Options
• Event Patterns
• Analysis Equations
• An Exerciser Program
Setting Analysis Options:
To set analysis options make sure that the Performance Analysis Tab has been selected
and click on the Advanced Options button in the Performance Analysis Dialog Box to
open the Analysis Type Setting dialog box shown below.
ANALYSIS TYPE
Entire Bus To count the events defined in the event file at all
addresses.
Address Override Specific Address and Events at a Specific Address selections override
the addresses set in the event file.
Specific Address To count only all of the address events defined in
the event tab.
Events at a Specific Address To count all of the events defined in the event
tab after the occurrence of the specific address
selected. This mode may be used to measure a
data burst rate of a specific transfer.
Specific Address Selecting the Specific Address or the Events at a Specific Address enables
address entry on the Performance Analysis dialog box.