Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 27)

Launching Your TA700/800 Catalyst Enterprises, Inc.
13
Launching Your TA700/800
The TA700/800 software is pre-configured at the factory to look for LPT2 as the
selected port for the analyzer. If the software finds this port connected to the analyzer
program will launch immediately otherwise the software will ask you to specify which
LPT/USB port is connected to the hardware.
If you have connected your hardware to a different port e.g. LPT1, USB or Ethernet
(TA850 only), select the that port and click OK to launch the analyzer program.
Find LPT Port If you are not sure which LPT port your hardware is connected to, check
“Search For LPT Port” then OK and let the software automatically locate
the LPT port that is connected to the hardware.
Find USB Port If you would like to use a USB port to connect to your hardware, check
“Search for USB Port” then OK and let the software automatically locate
the available USB ports to connect to the hardware.
Double click the TA700/800 Icon in the Program Manager Window.