Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 217)

Library Exported Interfaces Catalyst Enterprises, Inc.
203
GetTimingMasksAddress(ptrAddressMask)
Parameters
ptrAddressMask Returned value of Masking for address signals.
SetTimingMasksControl(bMaskValue)
Parameters
bMaskValue Specifies the Value of control Signal Masks parameter for next run.
Remarks The SetTimingMasksControll method sets the Value of Control
Timing Masks parameter for next run by bMaskValue.
GetTimingMasksControl(ptrControlMask)
Parameters
ptrControlMask Returned value of control Signal Masks parameter.
Remarks The GetTimingMasksControll method returns the Value of Control
Timing Masks parameter.
IUtilityServer
This interface allows the developer to get some TA board information such as attached LPT no or Bus Frequency which
is connected to TABoard. The methods which are available at this Interface are:
SetFpgaFilesPath()
SetInterfaceMode()
SetPortNumber()
AutoDetectSystemFrequency()
AutoDetectSystemFrequency (nSystemFrequency)
Parameters
nSystemFrequency Specifies the Bus Frequency of TA board connected.
Remarks The AutoDetectSystemFrequency method gets the Bus Frequency of
TA board is connected to the bus
Notice: To detect the System frequency, TA boards must be programmed by calling SetFPGAFilsePath
method first. Otherwise the TA may be not be found by the specified FPGA Path.
SetInterfaceMode (nInterfaceMode)
Parameters
nInterfaceMode Specifies the new Interface Mode for Next run.
Pass 0 for EPP Port.
Pass
≥ 1 for USB Port