Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 113)

TA700/TA800 as Target Catalyst Enterprises, Inc.
99
TA700/TA800 as Target
TA700/TA800 Enumeration
Once the TA700 is used in the System, it is enumerated. During the Enumeration the
Operating System assigns a memory and I/O address to your TA700 which is used as
TA700 Target Address. This will only happen if the S2 jumper is not installed and the
S1 switch is down. If the TA700 is used in a passive environment you may assign any
target address. To view the TA700 Configuration Space “Scan Configuration
Registers” on page 55.
Once you start the software, the TA700 will not respond to any transactions, including
configuration unless programmed on the Exerciser or Local Memory page.
Setting Target Operation
There are two ways to operate the TA700/TA800 as a Target.
1. By defining specific Target responses in the exerciser program.
2. By enabling Local Memory.
Defining Target Responses in Exerciser Program
On an exerciser program page, click the down arrow in the T1 LINE COMMAND to
choose a Target Termination.