Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 42)

Catalyst Enterprises, Inc. Easy Mode
28
Table 2. Pre-Defined PCI-X Trigger Points
1 Address Triggers on specified address
2 Any Interrupt Trigger when any interrupt occurs
3 Attribute
Triggers on a specific attribute phase with user defined address and
command
4 Burst Longer Triggers when the burst is longer than nnn times
5 Burst Shorter Triggers when the burst is shorter than nnn times
6 DMA Transfers Triggers when data burst is transferred
7 Data at Address Triggers on specified data at address
8 GNT# Triggers when GNT# is asserted
9 Master Abort Triggers when a master abort occurs
10
Occurrence of SERR# or
PERR#
Triggers when error SERR# or PERR# occurs
11 Protocol Error Triggers when any PCI-X protocol error is detected
12 REQ# Triggers when REQ# is asserted
13 Reset De-asserted Triggers when reset is deasserted
14 Asserted-Deasserted Signal xxx Asserted and then Deasserted for nnn times
15 Asserted Signal xxx Asserted for more than nnn times
16 Deasserted-Asserted Signal xxx Deasserted then Asserted for nnn times
17 Deasserted Signal xxx Deasserted for more than nnn times
18 Signal Shorter Triggers when signal xxx is shorter than nnn times
19 Target Abort Triggers when a target aborts
20
Target Disconnect at Next
ADB
Triggers when a target disconnects
21 Target Retry Triggers when a target Retry occurs
22
Target Single Data Phase
Disconnect
Triggers on target Disconnect termination.
23 Target Split Response Triggers on target Disconnects during burst.
24 Vendor & Device ID Triggers on Vendor & Device ID access