Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 134)

Catalyst Enterprises, Inc. Compliance Device Test
120
Executing a Saved Configuration
Run Previous Configuration To run a Compliance test with a previously saved configuration, click
Load and select a configuration file.
Specify the output file name where the test results are to be saved and click Start.
After clicking Start several messages may display, depending on the selected test, to
guide the user through the test.
Example Test
The following test (1.09) finds the addresses that are free for the TA700/800 as target.
Figure 107 Compliance Test Setup
Choose test (1.09) and click Add -> and then Start.
After a short time the device found dialog as shown in Figure 108 will open,
requesting you to perform an action.