Teledyne LeCroy TA700_800_850 User Manual - Manual (Page 194)

Catalyst Enterprises Inc. TA700/800 SPECIFICATIONS
180
Counter Use Count Accumulative count & reset as High Pass filter for triggering on
system crashes. Count & reset as Low Pass filter.
TIMING MEASUREMENT
Synchronous
Not Supported by PMC and TA800
Strobe Window strobe (2 edges)
Width 94 (64 bit PCI + control signals).
Resolution 100 Ps/edge
Operating Frequency 25 MHz to 67MHz
Spread 2-12 ns 33 MHz mode
2-5 ns 66 MHz mode
Glitch Detection 1.5 ns
Signals Any or all PCI bus signals may be included or masked individually.
Display Red flag on the data display for each PCI signal, identified by the PCI
signal name.
Asynchronous
Not Supported by PMC and TA800
Clock 664 MHz
Width 64 bit (selectable PCI control signals + addresses for AD [0 .. 31] or
AD[32 .. 63])
Resolution 1.5 ns
Memory Depth 512K
TIME TAG
Counter 40 bits
Resolution TA700 10 ns to 40 ns
TA700PDC 15 ns to 1.0 ms
TA800 7.5 ns to 1.0 ms
Recording Duration Up to 5 Hours at 15 ns, up to 10 Hours at 30 ns.
Reported display Absolute time from the start, Relative to trigger point, relative to each
data sample, Latencies for Target and Master.