NEC ExpressA1160 - Manual (Page 8)

Contents
viii
9.2.1. Viewing Information using ESMPRO Manager .................................. 9-3
9.2.2. Viewing Information using remote console interface ......................... 9-4
9.3. Setting Performance Thresholds using ESMPRO Manager .............. 9-4
9.3.1. Defining Threshold Values ................................................................. 9-4
9.3.2. Setting Threshold Limits for the Rate of CPU Load ........................... 9-7
9.3.3. Setting Threshold Limits for the File System Free Capacity .............. 9-7
9.4. Viewing Alerts .................................................................................... 9-8
9.4.1. Viewing Alerts using ESMPRO Manager AlertViewer ........................ 9-8
9.4.2. Viewing Alerts Issued by Management Firmware ............................ 9-10
9.5. Creating Graphs of Server Performance using ESMPRO
Manager ............................................................................................ 9-11
9.6. Adding Managed Systems using NEC Server Management ........... 9-12
9.6.1. Discovering Network Servers in ESMPRO Manager ....................... 9-13
Section 10 Troubleshooting Hardware Problems .................... 10-15
10.1. Overview of the Recommended Troubleshooting Sequence ......... 10-15
10.2. Determine the Affected System and Partition from An Alert ........... 10-17
10.2.1. Viewing Alerts Issued by Management Firmware .......................... 10-17
10.2.2. Viewing Alerts using ESMPRO Manager AlertViewer .................... 10-18
10.3. Determine the Affected System and Partition Using Your
Monitoring Software ....................................................................... 10-19
10.3.1. Monitoring with ESMPRO Manager ............................................... 10-19
10.4. Examine the Cell EXPRESSSCOPE® Monitor LCDs .................... 10-19
10.4.1. Fault Messages .............................................................................. 10-20
10.4.2. Viewing Fault Messages ................................................................ 10-21
10.4.3. Fault Messages on the EXPRESSSCOPE® Monitor LCD ............ 10-21
10.5. Examine LEDs (Optional) .............................................................. 10-23
10.5.1. LEDs on Front of Cell ..................................................................... 10-23
10.5.2. LEDs on Back of Cell ..................................................................... 10-24
10.5.3. LEDs not Visible Unless Cell Is Disassembled .............................. 10-26
10.6. Contact the Customer Support Center ........................................... 10-26
10.7. Examine the Management Firmware Event Log ............................ 10-27