NEC ExpressA1160 User Manual
Page 137
Configuring Alerts and the SMTP Server using remote console interface
7-3
described in
3.5.14 Alert Management
.
If you want to send alert notifications using e-mail, you must first configure the Simple
Mail Transfer Protocol (SMTP) server before configuring any email alerts. Refer to
7.2.1
Configuring the SMTP Server using remote console interface
for the procedure.
Refer to
7.2.2 Configuring Alert Notifications using remote console interface
and
7.2.3
Clearing Alert Destinations using remote console interface
for the procedures to
configure new or existing alert definitions.
Refer to
9.4.2 Viewing Alerts Issued by Management Firmware
for information about
how alerts appear when received.
Refer to
3.5.4 Sensor Readings
and
3.5.5 Event Log
for information about sensor
readings and event logs.
Refer to
Section 10 Troubleshooting Hardware Problems
for information about using
alerts in troubleshooting.
7.2.1. Configuring the SMTP Server using remote console interface
If you plan to send alert notifications using email, first configure the SMTP server before
configuring any e-mail alerts, as follows:
1. Navigate to the alert management page on the remote console interface for the
partition.
2. Click
SMTP Settings
.
The SMTP server address page appears, as shown in
Figure 7-1
.