NEC ExpressA1160 - Manual (Page 232)

Setting Partition MLAN Address using Management Firmware
12-6
2. Select user credentials in the table and click Delete User.
A confirmation dialog box appears.
3. Click OK to proceed.
The credentials disappear from the table.
12.5. Setting Partition MLAN Address using Management
Firmware
The partition MLAN address enables you to log on to the partition remote console
interface. When you enter the partition MLAN address in the browser address box,
management firmware displays the log-on dialog box. Refer to
2.1.2 Accessing and
Logging On to remote console interfaces for the log-on procedures.
You can change the MLAN address of the partition as follows:
1. Navigate to the network address page of the remote console interface for the
partition.
2. Select one of the following options:
y Obtain an IP address automatically (use DHCP)
y Use the following settings
3. If you selected Use the following settings, enter the following values:
y IP address. The MLAN address of the partition.
y Subnet mask. The IP address for the subnetwork.
y Default gateway. The IP address for the default gateway, router, or switch.
4. Click Submit .
Changing the MLAN address of the partition causes the current connection to
management firmware to be lost.
5. Wait several minutes and then enter the new MLAN address in the browser address
box to restore the connection to management firmware and log on to the remote
console interface.
12.6. Taking a Dump of Service Processor Data using
remote console interface
You can take a dump of Service Processor data for a partition or cell to send to the
support center for analysis, using the Service Processors page of the remote console
interface for the partition or cell. Refer to
3.5.24 Service Processor Functions and 3.7.6
Service Processor Functions for complete discussions and procedures.