Partition settings – NEC ExpressA1160 User Manual
Page 57
Partition Remote Console Interface
3-15
Figure 3-7 Field-Replaceable Units (FRU) Inventory Page
You can view information about each FRU in the partition or cell of the partition, as
follows:
1. Select Partition or the cell identifier in the Location list. The location determines
which devices appear in the FRU name list.
2. Select the desired device in the FRU Name list. The devices in the list depend on
the selected location.
Information about the selected FRU is displayed if available from the device.
3.5.8. Partition Settings
Each partition has unique settings, as shown in
Figure 3-8
,
Figure 3-12
, and
Error!
Reference source not found.
. The settings page enables you to set values for the
following groups of variables for each partition:
•
Power settings (refer to
3.5.9 Power Settings
)
•
Boot cell selection (refer to
3.5.10 Boot Cell Selection Settings
)
•
General settings (refer to
3.5.11 General Settings
)
•
Fault settings (refer to
3.5.12 Fault Settings
)
•
Customer data settings (refer to
3.5.13 Customer Data Settings
)