NEC ExpressA1160 - Manual (Page 229)

Configuring User Credentials using remote console interface
12-3
3. For New Private RSA Key in PEM format , browse to the location of the file
containing the desired custom SSL key.
4. Click Load .
The new values are loaded to the boot cell and displayed as the current values on
the Web page.
The new certificates are not loaded to other cells in the partition or to other partitions. If
you change the boot cell for the partition, you must load the SSL certificates again.
Because SSL certificates contain the Web server MLAN address, you must regenerate
them any time the MLAN address changes for a partition or cell. Each MLAN address
requires unique certificates.
12.4. Configuring User Credentials using remote console
interface
User credentials are the valid user ID and password values for logging on, along with a
network privilege for access to data and commands. Refer to
3.5.18 User Management
for more information. You can keep the set of user credentials up-to-date using the
following procedures for adding, modifying, and deleting user credentials.
12.4.1. Adding User Credentials using remote console interface
To add new user credentials
1. Navigate to the user management page of the remote console interface for the
partition (refer to Figure 3-17 ).
A list of sets of user credentials appears on the page.
2. Click Add User .
The add new user page appears, as shown in Figure 12-1 .