NEC ExpressA1160 - Manual (Page 139)

Configuring Alerts and the SMTP Server using remote console interface
7-5
If you want to return to the Alert Management page without changing the IP address,
click Cancel on the SMTP server address page.
7.2.2. Configuring Alert Notifications using remote console interface
You can configure up to 13 destinations for alert notifications using the following
procedure:
1. Navigate to the alert management page on the remote console interface for the
partition, as shown in Figure 3-13 .
2. Make one of the following selections:
• Select an existing alert destination that you want to modify or to send a test
alert to check its validity.
• Select a blank entry (the destination address is zeros) to define a new alert
destination.
3. Click Modify to modify an alert definition or define a new alert destination as an
e-mail or SNMP trap alert type.
The Alert Management - Modify page appears, as shown in Figure 7-2 and Figure
7-3 .
Figure 7-2 Alert Management - Modify Email